Astralpool FX Series Service Manual download pdf (Page 2)

SECTION 1. SAFETY INSTRUCTIONS

GENERAL

When you receive the pump, check the carton for damage. Open the carton and check the pump for concealed

damage, such as cracks, dents, or a bent base. If you nd damage, contact the shipper or the distributor where the

pump was purchased.

The pump must be placed on a solid foundation that will not vibrate and Fluidra USA recommends bolting the

pump to the foundation and providing for adequate drainage should any leaks develope.

SUPPLY WIRE SIZES (AWG)

Size and length based on horse power

BX CTX 115 volts 230 volts

50 ft. 100 ft. 150 ft. 50 ft. 100 ft. 150 ft.

½ ¾ 14 12 10 14 14 14

¾ 1 12 12 10 14 14 14

1 1.5 12 10 8 14 14 14

1.5 2 10 10 8 14 14 12

2 2.5 10 8 8 14 12 12

3 - - - - 12 12 10

Table 1

ELECTRICAL

All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.

When installing and using this electrical equipment, basic safety precautions should always be followed, including the

following:

The correct voltage and frequency as specied on the pump data plate is necessary for proper performance and

long motor life. Make sure that the wiring specication meets or exceeds the motor requirements (230v or 115v),

see the Table 1 (above) for recommendations.

1. When in doubt, use a heavier gauge (larger diameter) wire which helps the motor to run cooler and more

eciently.

2. Make sure all electrical connections are clean and tight.

3. Cut wires to the appropriate length so they don’t overlap or touch when connected to the terminal board, and

insulate all connections carefully to prevent grounding or short circuits.

4. Permanently ground the motor using the green ground terminal located on the inside of the motor canopy,

under access plate.

5. Use the correct wire size and type specied by National Electrical Code, “NEC” (or Canadian Electric Code, “CEC”,

for Canada). Make sure the ground wire is connected to an electrical service ground.

6. Electrically bond the motor to the pool structure in accordance with the National Electrical Code (or Canadian

Electric Code for Canada). Use a solid No. 8 AWG or larger copper conductor.

7. Additonally, run a wire from the external bonding point to the pool bonding structure following the NEC/CEC.

8. Connect the pump to a permanent/dedicated circuit. Make sure no other lights or appliances are on the same

circuit.

WARNING

Make sure all electrical breakers and switches are turned o before wiring motor.

1 2 3 4 5 6 7 ... 15 16

No comments

Astralpool FX Series Service Manual Page 2